Answer / dhruvin patel

Earthing is used for personnel safety and to ground leakage current , the metal body of equipment connected to ground it called earthing and neutral point in 3-ph ckt which connected to ground is called grounding in this grounding unbalance current flow (normally Zero).

Answer / sarmadahmed

Grounding is used for referencing the voltage. A common point is taken.
Earthing is used for safety purpose, a conductor is connected to ground or any other safe medium, giving a low resistance path for current to pass as to avoid any effect of surges.

Answer / sundar

The term earthing and grounding are same. The united states
terminology is grounding and rest of the world termed as
earthing.

what will be the effect on a bulb in case its connetion is change from live and neutral to live and ground??? 1) in case of single phase AC supply 2) in case of DC supply.......???

1 Answers  

---

how the aircraft outer body and inner body is separated ?

0 Answers  

---

auto reclosing scheme for radial ehv feeder is to be implemented or not?

1 Answers   State Board,

---

why transformer fuse wire is very thin as compared to home fuse wire while voltage lavel is low

1 Answers  

---

What is Plank's Law?

0 Answers   Godrej,

---

What difference between voltage and current

5 Answers  

---

WHAT IS THE CURRENT CARRYING CAPACITY OF 2.5/3 CORE HI TUFF CABLE,WILL IT SAFLEY CARRY 8.6 AMPS OVER 120 METRES,CAN YOU ALSO ANSWER WITH FORMULA FOR WORKINGS OUT ,THANK YOU 3RDYR APPRENTICE.

0 Answers  

---

What is resolution of a measurement?

0 Answers  

---

why indicated sypply only by 440V in 3-phase system.

2 Answers  

---

star delta starter contorl circuit... drawing..

0 Answers  

---

Why Nutral CT rating for Earth Fault Protection of Transformer neutral shall be 20% of Full load Current of Transformer

2 Answers  

---

What is LMU and LMDU. in PLCC communication of 132 kv transmission line. is it possible to use only one LMU with out LMDU ?

1 Answers  

---