why we are maintain phase to phase clearence

Question Posted / jayanta dey

4 Answers
6943 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why we are maintain phase to phase clearence..

Answer / shyamkr

TO NETRILIZE THE EFFECT OF CAPACITANCE AND INDUCTANCE IN
BETWEEN TWO PHASE LINES.
IF THIS MINIMUM DISTANCE IS NOT KEPT BETWEEN PHASE LINES IT
CAN INTERACT WITH ADJACENT PHASE.

Is This Answer Correct ?

4 Yes

0 No

why we are maintain phase to phase clearence..

Answer / k s patil

prevention of carrona effect between two phases & short ckt.

Is This Answer Correct ?

4 Yes

1 No

why we are maintain phase to phase clearence..

Answer / sunil guru

A)TO REDUCE THE EFFECT OF CORONA --- OTHERWISE THE DRAWBACKS ARE
1.CORONA CAN CAUSE TELECOMMUNICATION INTERFERENCE
2.IT CAUSES CHEMICAL REACTIONS
3.RESULTS IN OZONE FORMATION
4.IT PRODUCES REDDISH,BLUISH GLOW NEAR THE SURFACE OF THE CONDUCTOR

B)TO REDUCE THE FEAR OF SHORT CKT AT THE TIME OF FAULTY WEATHER OR STORMY WEATHER.

C)TO NEUTRALIZE THE EFFECT OF SHUNT CAPACITANCE AND MUTUAL CAPACITANCE AND INDUCTANCE

d)AND WHILE DESIGNING THE TRANSMISSION LINES THEIR IS A MINIMUM SAG KEPT TO MAINTAIN THAT SAG VALUE AT DIFFERENT WEATHERS REQUIRED PHASE 2 PHASE CLEARANCE IS KEPT........

4 ANY DISAGREEMENTS PLEASE MAIL AT parmar20072008@yahoo.com

Is This Answer Correct ?

2 Yes

0 No

why we are maintain phase to phase clearence..

Answer / jitesh patel

BECAUSE TO REDUCSE THE EFECT OF CAPACITACE & INDUCTANCE
BETWEEN THAT PHASES.

Is This Answer Correct ?

2 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

how nautral is provided for return path is 3 phase induction motor

0 Answers SNGPL,

What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?

0 Answers Honeywell,

How we can change the direction of rotation of Induction motor? Prove it using graphical methods.

2 Answers

Please explain me abt PQ diagaram in the power sector.

0 Answers

what is effect of 5amp fuse on 2mva pry protection of transformer

0 Answers

How many types of circuit loads are there in a common electrical circuit?

0 Answers

Why used in netural grounding transformer for netural side

2 Answers

why always out of the 3 phase(RYB) of supply, in Y phase w.r.t the voltage is higher? on R & B phase the voltage will be lower as compared to Y phase?

1 Answers

Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???

0 Answers

what is mean by PID & Principal of working

6 Answers

When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt

0 Answers BMRCL,

Why fuel tanks to be earthed ?

6 Answers Electronics, Hindustan Petroleum, HPCL, Ispat,

For more Electrical Engineering Interview Questions Click Here