Answer / Ashish Mani Tiwari

To install a High-Tension (HT) Panel, you'll need the following components:
1. Busbar or Bus Section
2. Current Limiting Fuse
3. Circuit Breakers
4. Distribution Transformer
5. Isolators/Switchgear
6. Wiring and Cables
7. Earth Leakage Circuit Breaker (ELCB)
8. Metering Devices
9. Main Contactors

A detailed diagram of a HT panel would include the arrangement of these components and their interconnections, specific to your application. It is recommended to consult with an electrical engineer or refer to installation manuals for accurate information.

what is high - pot test. what's its use?????

1 Answers  

---

what are the protecyion of transformer & generators

1 Answers  

---

Where servomechanism is used?

1 Answers  

---

how we done power management?

1 Answers  

---

keeping in view of parallel operation which of the 3 phase transformer connection are possible? a)delta-delta to delta-star b) delta-delta to star-delta c) star-star to delta-delta d) delta-star to star-delta

4 Answers   Ecil, Siemens,

---

i applied for the ap transco please forward the freqventley asked QA

1 Answers  

---

What do you mean by dependent and independent voltage sources?

1 Answers  

---

By just seeing a transmission tower, how can we knew the voltage it carries..?[110kv, 220kv, 400kv...]???

5 Answers   KSEB,

---

when we switch on the switch and load is not connected at home,is electricity wasted?

1 Answers  

---

Why generator field rheostat is set to maximum position and motor field rheostat is set to minimum?

5 Answers   Bhel, College School Exams Tests, TCS, Texas,

---

Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC

1 Answers  

---

does the power factor of an induction motor improve upon used in parallel with a synchronous condenser , used commonly to provide a leading kva ?

1 Answers  

---