Answer / sudhir kumar

trafo mainly step down the voltage from 240v to 24v which is basically used in industry for the temporary supply of flood light , hand lamps etc..

In my project i am layout cables under the Maintainance bay /Maintainance yard in the TG Building. Whether in this route i can lay the H.T.Cables??? i am taking all H.T cables from the H.T Transformer to the TG Building..

1 Answers  

---

what is the diffrence between mcb &elcb?

2 Answers   Kahramaa, Synergy,

---

what is the chiller and working principal

0 Answers   Blue Star,

---

what is sf6 where it is use & working or function ?

5 Answers  

---

if the magnetic lines can pass through a vaccuum area

0 Answers  

---

how to deside the capacity of chock for drive?

0 Answers   Essar,

---

What are the properties of a resistor?

0 Answers  

---

What is a slack bus?

0 Answers  

---

why two wires are wound alternately to each other in single phase wires?

1 Answers  

---

What will be the effect of in HT XLPE 220 KV cable when one side of the Armour/cable ends are not grounded. Will there is difference between 3-phase voltages? like: if A. Both End of Cable grounded Phase Voltages:- V1=219 KV, v2=220 Kv, v3=220 KV. B. One End is grounded other is not: than Impact on Phase Voltages:- V1= KV, v2= Kv, v3= KV. Remain same or unchanged??

3 Answers   Jamshoro,

---

Suppose the incoming power is 11 kw, but the load require only 8 kw means how can we save or use the excess power?

3 Answers  

---

NGR? What is NGR?

14 Answers  

---