I want to know if it is possible to use Variable Frequency Drive to reduce the

I want to know if it is possible to use Variable Frequency
Drive to reduce the current required for starting a motor?

Question Posted / masood said

3 Answers
5115 Views
Descon, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

I want to know if it is possible to use Variable Frequency Drive to reduce the current required fo..

Answer / muili ibrahim babatunde

VFD is an acronym for variable frequency drive. It is not meant for varying frequency only, It also reduces current starting.

Is This Answer Correct ?

1 Yes

0 No

I want to know if it is possible to use Variable Frequency Drive to reduce the current required fo..

Answer / guest

Yes.

Is This Answer Correct ?

1 Yes

2 No

I want to know if it is possible to use Variable Frequency Drive to reduce the current required fo..

Answer / guest..

no.. how is this possible? i dont know... vfd used for rpm increase r decrease... this one posible... i think..

Is This Answer Correct ?

1 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

if 400kv line is connected to the load but neutral ii not be connceted then wt ll happen

1 Answers

150 hp moter how many kwh in 1 hour and what forfula 3 phase kwh.

5 Answers College School Exams Tests, CPCL, Syncom, Thermax,

why the under of transformer platform is filled with rock stones.

10 Answers TNEB Tamil Nadu Electricity Board,

how many desk top computer can connect to a 25kva 3phase generator?

1 Answers

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

0 Answers

What's the difference between non break power supply and non break non short break power supply

0 Answers

What is WLD System????

3 Answers Emerson, HCL, Honeywell, Tata Communications,

HOW CIRCUIT BREAKER RATING CALCULATED?WHAT ARE THE PARAMETERS CONSIDERED?

5 Answers

Why let through energy not considered for ACB breaker while cable sizing?

0 Answers

How to conduct the Magnetic Balance test on Power Transformer?

0 Answers

How to calulate Locked rotor amper(LRA) for compressor type motors?

0 Answers MAF Dalkia,

why neutral is neccessary?

7 Answers

For more Electrical Engineering Interview Questions Click Here