Answer / thowsif_emerson_csm team

Hi Dear :)

Pls find the bellow links:-

For DC Machines:-
http://www.reliance.com/mtr/mtrthrmn.htm

For DC Motors:-
http://ecmweb.com/ops/electric_direct_current_motor/

Answer / ramya

tnk u dr

how terminal voltage increases when load is capacitive (leading pf load)? (explain practically what is happening, not using phasor diagram

1 Answers  

---

why there is a 2 slits in three pin's earthing pin?

1 Answers  

---

why cu losses called cu losses.

6 Answers  

---

What happens to a line-frequency of high-frequency transformer when it is first energized/ re-energize?

0 Answers  

---

how did the differential relay work to protect the power transformer

4 Answers  

---

why we not use capcitor in Three phase motor ??

2 Answers   GOMS, Power Electronics,

---

What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?

0 Answers   SCS,

---

PAC and simple Ac different

0 Answers  

---

What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?

0 Answers   Jindal,

---

how we can calculate 2 phase welding transformer rating or total power?

0 Answers  

---

Why winding temperature ct placed in B-Phase of the transformers?? 

3 Answers  

---

Energy metering: On the property I am renting, the supply voltage is 2 x 110 volts. These 2 x phases enter a energy meter which then exit the meter to over head lines to my house. Question 1. The meter is single phase 240 volts but is being used as 2 x phase(2 x 110volt), is this acceptable? if not, please give me the reasons. The meter details are as follows: 60Hz 15amp Imax 100 amp Kd 3,6 Wh/R 1 fase 3 hilos Model FX 231. I think it was manufactured in Brasil From this meter, the cables run along over head aluminum conductors,I estimate the cross sectional area to be 25mm diameter, but the neutral is only about 10mm square diameter, which cover a distance of 170 meters and then terminate with an underground cable of 65 meter length, total length = 235 meters. There must be a huge voltage drop over this length. This line is protected with 2 x 200 amp aluminum fuses after the meter, there is no main switch in the distribution board. These 2 phases connect directly onto 2 busbars. Surely the neutral should be the same size as the conductors if not more? Question2. What are your thoughts about this installation, should there be better protection, is the neutral too small? During the night, the lights dim then brighten all the time, this cannot be good for my electrical appliances. In my home, I only have a small electric geyser and fridge, my stove works off gas. But when i use other appliances like the washing machine or microwave oven, the light dim. The internal wiring of this house is done with solid hard drawn copper wires and of course, they have to be under rated. I am a retired electrician by trade, but not on the metering and over head mains side, my experience is on the factory maintenance side of things. Your expertise on these matters will be greatly appreciated. Please inform me how to rectify or make any improvements Kind regards, my power bill is very expensive, so I need to know how to bring it lower. Kind regards, Brian

1 Answers  

---