When we design PI controller, when we design PID controller
& is there any ID controller ?
When we design PI controller, when we design PID controller
& is there any ID controller ?
Explain the working of Incubator Box which is a PI
controller ?
Answers were Sorted based on User's Feedback
Answer / nitin bishoriya
PI stands for proportional integrator controller. In this
system input to a system is composed (SUM) of two signal.
One is the input that we applied and second integral of
feedback from output. Advantage of using PI is that steady
state error is reduced that is effectively not possible by
using proportional alone signal.
PID=proportional +integral +derivative of feedback from
output.
No there is not ID controller but there is integral
controller system.
As i have already mentioned that PI is used to reduce
steady state error.
We we want to improve damping ratio besides improving error
signal then we use PID
| Is This Answer Correct ? | 5 Yes | 0 No |
Nitin Bishoriya
Kindly gimme your email addresses if you can so i may
communicate you more
thanks
regards
dinesh deshmuk
| Is This Answer Correct ? | 0 Yes | 0 No |
what is function of FIU 19,
what is the uses of VSB?
What is the state if the RED LED is glowing on DVxx card What is the state if the YELLOW LED is glowing on DVxx card What is the state if the GREEN LED is glowing on DVxx card Which frequency band DVDC is used Which frequency band DVGA is used What is the function of Bias Tee (BPxx) Which power supply card required for Ultra BTS for AC 230 V input Which power supply card required for Ultra BTS for DC -48V input Which power supply card required for Ultra BTS for DC 24V input What is the state if the GREEN LED is glowing on PWSx card What is the state if the RED LED is glowing on PWSx card What is the state if the YELLOW LED is glowing on PWSx card How many maximum PWSA cards can be inserted in a Ultra BTS cabinet How many maximum PWSB cards can be inserted in a Ultra BTS cabinet How many maximum PWSC cards can be inserted in a Ultra BTS cabinet What is the output power rating of one PWSA card What is the output power rating of one PWSB card What is the output power rating of one PWSC card What is the function of Receiver Multicoupler (M2xA or M6xA) How many TRX's are supported by one Receiver Multicoupler- M2xA How many TRX's are supported by one Receiver Multicoupler- M6xA What is the function of Remote Tune Combiner (RTxx) unit
Why half-wave rectifiers are generally not used in dc power supply?
what must be the kind of test on innovatronix
Electronic technical analysis
What is meant by commutation?
what is mean by regulation?which component used?
Hi i am going to attend the interview for BHEL. can you please help out in knowing about the area of preparation. I am apprearing for supervisor trainee post. i have done diploma + B.tech. suggest answer of question that don't you think that you are overqualified for this job. thanks rahul
In a binary data sequence, the duration of symbol 0 or 1 is 1ms. If a carrier of freq 4khz is used in ask, what is the minimum transmission bandwidth required? What is min bandwidth?
How the trx is assigned to e1 channel?
What are the pros of using plasma screens.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)