Answer / Vikas Deval

Dead-end protection is a protective relaying scheme used for unloaded feeders or lines that do not have connections at both ends. It prevents the flow of current in reverse direction and protects the line from overloading during fault conditions.

What is the source of dependent source ?

1 Answers  

---

seromechanism

4 Answers   Bhel,

---

How can calculate thermal overload in relay?

1 Answers   ABB,

---

What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?

1 Answers  

---

Which colour of earthing wire

1 Answers   Aravali,

---

1.what type of oil used in tranformer. 2.oil vesocity. 3.oil gauge. 4.witch time oil filterring & how much temperature maintaned.

9 Answers   NTPC, Reliance,

---

what ever the ups kva it may 500 kva or 500 va always out put is AC 240 volts its right?

3 Answers  

---

What will happen 50 HZ motor when you will give 60 HZ?

7 Answers   Bhushan Power Steel,

---

For Bus duct hi pot test, where we want to connect the return and ground leads?

2 Answers  

---

what is meant by motor startup supervision & motor load jam protection ?

1 Answers   ABB,

---

Name the test signals used in control system

1 Answers  

---

What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.

1 Answers   ABB,

---