Answer / tu harsu

it depends on how you do it if you take a press m/c to form
it into a pipe then just calculate by integration as you
consider a line forcing an a fibre at any angle along the
peripheri of the circle.

Answer / iqbal

it depends upon the thickness of sheet and required diameter
to be formed from the sheet.

What is the difference between tube and pipe?

0 Answers  

---

DIFFERENCE BETWEEN QA & QC

4 Answers   L&T,

---

Why stainless steel is corrosion resistant?. What is stress corrosion cracking?.

6 Answers   Dr Reddys, IGCAR, Reddy Labs,

---

What is the shaft coupling and its types.

9 Answers   Kirloskar, KKR,

---

what is the main difference between shaft and axle..?

4 Answers  

---

what is Production Planning&schedule?

1 Answers   L&T,

---

Pls send me the 10 years technical question paper of Jindal steel power to my email id

12 Answers   Jindal, Jindal Steel and Power, Tata Steel Limited,

---

what is danda & funda

1 Answers  

---

Why is thick steel wire stronger than thin steel wire?

0 Answers  

---

What is meaning of due point in air Compressor system?

1 Answers  

---

What is the common source of leak in stern tube

0 Answers   RRB,

---

1.an you please send all INTERVIEW Unigraphics/ansys QUESTIONS&ANSWERS. structural analysis,linear,nonlinear analysis,modal,harmonic analysis all questions @answers? Send all typical HR questions &answers?

3 Answers   Kennametal, Sandvik,

---