What is standard sand?
What is coarse & fine sand?
What is foundation?
What is the seze of hooks in various Reinforced section?
What is the formula of providing clear cover?
What is the basic diff. between working stress & Limit
state design?
What is &cbc and fck?
what are the primary & secondary test of water purification?
Answers were Sorted based on User's Feedback
Answer / sjtbehera
Standard sand means which obtained from nature, like river
sand
According to IS code sand which passes lower than 4.75mm
and above 600milimicron and fine sand which passes 600 mili
micro and retained 75 mili micron.
Foundation is the part of structure which transfer load of
the structure to the base of soil on which it rests.
hooks- semicircular secn.-16d
90' bend- 8d
45' bend- 12d
Clear cover- column-40mm
BEAM - 25MM
SLAB - 15MM
FOOTING - 50MM
lIMIT STATE DESIGN- in this method design based on limit
state concept, the structure shall be designed to with
stand safety of all loads liable on it throughout its life.
it also satisfy the serviciablity recquirments such as
limitation on deflection and cracking. the acceptable limit
for the safety and serviciable recquirment before failure
occurs is called limit state.
working stress- when limit state design are not acceptable
working stress method is used. in this method is based on
elastic theory.
cbc- compressive strength
fck- charterstics strength
Is This Answer Correct ? | 60 Yes | 10 No |
as standard sand we can uesd madras sand it is clean,well
graded,wthite,
sand which in retain on 4.6 mm in called coarsed sand
and retain on 2.36 mm is called fine sand
generaly clear cover is based on max. size of aggregate
which is uesd for concreating work see is 456
ph volue is carried on water
Is This Answer Correct ? | 9 Yes | 13 No |
What is factor not to be taken in consideration in mix design?
How to calculate canal slope curvature qty!
On what basis we decide the formation level of the road? other then that of 50% Cutting and 50% Filling??
what is the water cement ratio of 1:6 and 1:4 cement sand mortar. reply soon
What is demising walls?
Define angular dimension?
It needs contour survey before plastering a wall / column & floor tiles setting to get––
what is the quantity of cement( in bags),sand and aggregates required for 1 cmt of M 25 concrete
What is difference between limit state and working stress method? How it is applies in building structure.
how to find fineness modulus of sand?
what is the cut length for Fe 500?
How many binding wire is use in arrangement of 25mt steel