What is the torque required at M6, M8, M10, M12, M14, M16, M18, M20, M22, M24

What is the torque required at M6, M8, M10, M12, M14, M16,
M18, M20, M22, M24 M.S&S.S Bolt or give me any chart for
this?????????

Question Posted / shri..

1 Answers
3395 Views
Mico, I also Faced
E-Mail Answers

What is the torque required at M6, M8, M10, M12, M14, M16, M18, M20, M22, M24 M.S&S.S Bolt or..

Answer / kush yadav

For M6 40-50, M8 55-65, M10 60-70, M12 70-80 M14 75-85, M16 80-90 M18 90-100, M20 100-110, M22 105-115, M24 110-120..

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

Action plan to closr NCR (NON COONFORMANCE REPORTS)

0 Answers

Explain how does a super charger work in a car?

0 Answers

If an ID Fan is designed for a suction pressure of - 250 mm wg and discharge pressure of +150 mm wg, and it is installed in a system where the required system resistance at suction is only -50 mm wg, will the ID Fan be able to produce a discharge pressure of +350 mm wg?

1 Answers

How much fuel is to be burn for production of 1 ton steam?

0 Answers

wat is the difference b/w stress and pressure?

11 Answers IMA, L&T, NTPC,

when splined shafts are preferred over keys?

1 Answers

Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.

0 Answers

what is strain

12 Answers NHPC,

"What is the remedy if due exchanging, valve broke out during engine running operation?"

0 Answers RRB,

How to know the bearing number if we know the shaft diameter and RPM?

1 Answers TCH,

How fuel oil consumed by medium engine?

0 Answers RRB,

please let me know the book for preparing to section engi and loco pilot bangalore

0 Answers

For more Mechanical Engineering Interview Questions Click Here