Answer / muthuramalingam

it's should be minimum 1.75 mtr from ground level i thing so

Answer / k.prakashchandra

There is no standard height and it is to your convenience

What are the characteristics of negative feedback?

1 Answers  

---

My ups output shows 230 v between phase and neutral,but show zero between phase and earth.Is the system/installation is correct.If not what will be the possible reasons

4 Answers  

---

what is earthed and inearthed cable or system?

1 Answers   CCCL, L&T,

---

why, when birds sit on transmission lines or current wires doesn't get shock?

36 Answers   College School Exams Tests, Infosys,

---

WHY DOES NEUTRAL DO NOT CARRY EVEN THOUGH IT CARRIES RETURN CURRENT?

3 Answers  

---

how to decide the panel size like MDB ,SMDB PANEL SIZES

1 Answers  

---

What is the use of Isolation Transformer, and Neutral is using for return path, finally this current is going.... but same time the voltage of the neutral should be below 1 V...

6 Answers  

---

what is load which is indicated in power plant generation panel? in any power plant

1 Answers  

---

what is stator inter turn fault?

1 Answers  

---

Why machine give shock

3 Answers   Akij, Bhel,

---

In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes

1 Answers  

---

How much DC or AC Current that a Human Body withstand for Electrical Shocks?

4 Answers   Suzlon,

---