Compare Brayton and Otto cycle.




Answers were Sorted based on User's Feedback



Compare Brayton and Otto cycle...

Answer / v.vijay reddy

Otto cycle is the ideal cycle for spark ignition eng's.
-Brayton cycle is the ideal cycle for gas power turbines.

Is This Answer Correct ?    68 Yes 13 No

Compare Brayton and Otto cycle...

Answer / aswin yuvaraj kumar v

In Brayton cycle Heat Addition take place at constant pressure, whereas in Otto cycle Heat Addition take place at constant volume.

Is This Answer Correct ?    54 Yes 1 No

Compare Brayton and Otto cycle...

Answer / vignesh.p

Otto cycle:here heat addition
and rejection takes place at
constant volume.so it is called
constant volume process.it is
used in petrol engine
whereas in Brayton cycle:heat
addition and rejection takes
at constant pressure.so it is
called constant pressure
process.it is used in
gasturbines,turboprop and
turbojet engines.it is having
greater efficiency than otto
cycle

Is This Answer Correct ?    36 Yes 3 No



Post New Answer



More Mechanical Engineering Interview Questions

Please send me technical paper of ONGC for Mechanical branch.I am in need of the paper.Pls send me.

3 Answers   ONGC,


What are the causes of boiler backfire and steps in how to prevent it from happening?

4 Answers   RRB, Siemens, ABC Inc,


what is the efficiency of horizontal & vertical feed water heaters?

0 Answers  


What will happen when engine stays in critical speed of 58-65 RPM?

1 Answers  


Why are not use ball bearing insted of roller bearing?

0 Answers   Ravi Biotech,






How much stack emmission through your chimney and what is the state govt norms ?

0 Answers   Jindal,


how to calculate weight of MS Plate and Square Tubercular section??? formula

1 Answers   TATA, Relyon,


where does stuffing box is placed

3 Answers  


What is breather frequency of tank?

0 Answers   IOCL,


what is ERW PIPE & Seamless PIPE Out of ERW and Seamless which one gives good results for an impact force of 2700 N??

2 Answers   NTPC,


If a cantilever beam is loaded with point load at its free end and when the load increases at which section it will break first?

5 Answers   TATA, Government,


. how will effect of water injection on turbine load and corresponding MW output(not water washing)

0 Answers  






Categories
  • Civil Engineering Interview Questions Civil Engineering (4635)
  • Mechanical Engineering Interview Questions Mechanical Engineering (3700)
  • Electrical Engineering Interview Questions Electrical Engineering (15765)
  • Electronics Communications Interview Questions Electronics Communications (2636)
  • Chemical Engineering Interview Questions Chemical Engineering (762)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (79)
  • Bio Engineering Interview Questions Bio Engineering (30)
  • Metallurgy Interview Questions Metallurgy (95)
  • Industrial Engineering Interview Questions Industrial Engineering (199)
  • Instrumentation Interview Questions Instrumentation (2879)
  • Automobile Engineering Interview Questions Automobile Engineering (171)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (41)
  • Marine Engineering Interview Questions Marine Engineering (62)
  • Power Plant Engineering Interview Questions Power Plant Engineering (169)
  • Engineering AllOther Interview Questions Engineering AllOther (1334)