How should i design a 1ph & 3 ph transformer. Kindly let
meknow all steps and formulaes related to design from
scratch.
No Answer is Posted For this Question
Be the First to Post Answer
WHAT WILL BE THE SPEED OF MOTOR IF NO.OF POLES ON STATOR ARE NOT EQUAL TO NO. OF POLES ON ROTOR.???
One of the advantages of HRC fuse links is that they can be used to back up equipment with an inadequate rupture rating. briefly discuss what this means
Is it reuired to use house service barcket for 31/2 core 300 Sq.mm cable,if the distance between pole & shop is around 2 mtrs only or can I hang the cable with GI support in air? upto what size of cable GI serrvice btacket is necessary?
What work have you done on full chip Clock and Power distribution? What process technology and budgets were used?
0 Answers Divis Laboratories, Intel, Sainor Labs,
what is motor?
HOW DISTANCE PROTECTION IS DONE IN EHV TRANSMISSION LINES? WHAT IS THE BASIC TECHNIQ OR FUNDA USED BEHIND THIS ? SPECIALLY EXPLAIN?IMPEDANCE METHOD.
Maintenance of transformer???
in 3 phase induction motor resistance value is how much
what is the diff. between power transformer & distribution transformer.....
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
what percent do you derate your copper wire when you change from copper buss to copper wire
why do we provide metallic enclosure to bus duct and then ground it?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)