difference b/w series&parallel

Question Posted / vasanth kumar

4 Answers
7175 Views
ABB, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

difference b/w series&parallel..

Answer / dhaval

electrically to ckt. series and parallel,
series:
1.current same in each resi.
2.voltage divide each resi.
it's means series ckt. current same following but voltage drop in resistance.
parallel:
1.current divide in each resi.
2.voltage same in each resi.

Is This Answer Correct ?

22 Yes

0 No

difference b/w series&parallel..

Answer / chaitu

in a electrical/electronic circuit 2 or more sections or
branches are said to be series if current in them is
same, if voltage is same and curren is shared/ divided
as per restitances of loads its said to be parallel
Checkchaitu@yahoo.com

Is This Answer Correct ?

7 Yes

4 No

difference b/w series&parallel..

Answer / natchi

in series circuit resistance value is high,but in parallel circuit resistance value is low for same power rating and current is constant in series circuit, voltage is constant in parallel circuit

Is This Answer Correct ?

4 Yes

1 No

difference b/w series&parallel..

Answer / simon

Eg U have 2 Batt of 12v 150Ah. If u connect in series the output will b 24V 150Ah & in Para u will get 12 v 300Ah.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

how does grading rings & spacers in transmission line works? Working Principle?

0 Answers

Describe the method of Plate Earthing.

1 Answers

* Signal transmission in sky wave propagation is due to ? a) Reforction of wave b) Reflection of wave c) Pierus through Inosphere d) None and Reason for this is????

2 Answers

1.what type of oil used in tranformer. 2.oil vesocity. 3.oil gauge. 4.witch time oil filterring & how much temperature maintaned.

9 Answers NTPC, Reliance,

How many types of probe used in cro?

0 Answers

why current coil has less number of turns compared to pressure coil?

8 Answers Airtel,

What is the minimum distance between MV busbare (P to P & P to E) as per some standards

1 Answers ABB, Sejong,

If the damper winding on the rotor of a synchronous motor is removed after starting what will happen?

7 Answers IOCL,

Why dose voltage rated at 11kva

1 Answers TK Chemical Complex,

HOW TO CALCULATE THE VT SIZING?

0 Answers L&T,

How to obtain B license from TNEB license board. What is eligibility?

11 Answers Core, Reliance,

As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.

0 Answers

For more Electrical Engineering Interview Questions Click Here