What happens with squirrel induction machines if the ends of rotor conductors are kept open? Explain

5 Answers  

---

I hv a question regarding power factor improvement just after transformer. I request you to reply me plzz. thank you sir. My friend has a small unit of fabrication. in his factory the main load is a welding machine, lathe machine, grinding machine. this load is not continuous type. now our electricity board has installed 16 KVA, 11000/433 V transformer for our factory. In the energy meter (trivector meter) at LV side of transformer, i hv seen power factor value of 0.15 only when only 3 KW load was flowing. Further electricity board has suggested to install 4 KVAR capacitor at LV side after energy meter. Now my question is that if we permanantly install and switch on 4 KVAR capacitor after energy meter, during some load on transformer and also without any load on transformer, wht will be the power factor shown in energy meter?i dont want to get any penalty by electricity board, so plz suggest me if i can permanantly install and switch on the 4 kvar capacitor or not at LV side of transformer just after energy meter? Thank you again and awaiting for ur positive reply soon.

9 Answers  

---

what is V.L.F. testing of power cable? do you know the voltage ratings, like for what rating and size of cable what rating of V.L.F. testing is used?

0 Answers   Reliance,

---

how much current (in MW)can be carried max. through S/C dog & Panther Conductor ?

1 Answers  

---

A 2D array X(7,9) is stored linearly column wise in a computers memory.Each element requires 4 bytes for the storage of the value.If the first byte address of X(1,1) is 3000,what could be the last byte adress of X(5,8)?

2 Answers   TCS,

---

what is the minimum winding resistance of 30hp compressor, to run or to switch on

0 Answers  

---

how much percentage set in transformer diffrencialrelay

1 Answers  

---

what are the condition that makes hooter blow?

0 Answers  

---

What is difference between start imitation and start interlock for 3 phase motor protection ?

0 Answers   Siemens,

---

Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?

0 Answers  

---

if the supply voltage increased by N times, the x-section of conductor will be.........

2 Answers   APGenco, Electrical Tech, Ericsson, IES, Thirumalai Chemicals,

---

sir i had plane to do some project with the base of hopkinson test in AC supply its possible

0 Answers  

---