Answer / faiyaz

ESD means emergency shutdown valve its used in flow line its generally fully open and fully closed its control by the dcs system when plant would need to be maintenance or any thing will happen in side the plant ESD valve will be closed.
PLC stand for programmable logical controller its industrial computer system which is used to monitoring and control the input output system

how to check the leak in thermowells

1 Answers  

---

what is meant by turn down ratio?

3 Answers   Avant Garde,

---

Where is the flow transmitter installed with respect to control valve, state reason.

1 Answers   ADMA OPCO,

---

explane hart protocol? what is its advantages.

3 Answers   Jindal,

---

what is interlock system and why we use of this?

0 Answers  

---

What is the difference between a PLC (Programmable logic controller) and DCS (distributed control system)?

7 Answers  

---

can we use flow transmitter instead of level transmitter?

7 Answers  

---

Thermocouple is a transducer but rtd is not transducer why? Both taking heat as a input and giving mv

7 Answers  

---

The wire is disconnected from the fuel gauge sending unit (bimetallic gauge). A voltmeter connected to the wire reads a pulsating 5v. What does this indicate?

3 Answers  

---

If a transmitter is installed 10 m below its tapping point how much pressure exerted if fluid is water?

10 Answers   QAFCO,

---

What is the purpose of valve positioner. Explain 4 uses.

2 Answers   SRACO,

---

how ranges is decided for drum level or dearator level,in my pplant i have seen for boiler drum range is -1000 to 1000mmwc, while for dearator -2000 to 0 mmwc ,why they decided to take this range ?

2 Answers  

---