Answer / sindhu

1. by using flux control method:in this method a rheostat is connected across the field wdg to control the field current.so by changing the current the flux produced by the field wdg can be changed, and since speed is inversely proportional to flux speed can be controlled
2.armature control method:
in this method a rheostat is connected across armature wdg.by varying the resistance the value of resistive drop(IaRa)can be varied,and since speed is directly propotional to Eb-IaRa the speed can be controlled

Answer / sennapparajan

can be controlled through triac. we have done our project.
speed control of DC shunt motor using triac.

I have installed capacitor bank at secondary transformer. cos phi is increase. but on load (far from transormer), it still poor. Can anybody explain it??

6 Answers  

---

What cmos is and its benefits?

0 Answers  

---

Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?

0 Answers  

---

can HT cable or HT bare conductor used for LT line? is yes what would be the current rating?

2 Answers   ACC, wbsedcl,

---

For 35 HP motor how much amount of capacitor should be on in kvr to reduce the current bill

1 Answers  

---

---

what is the difference between equipment earth and system earth.

1 Answers   Hofincons,

---

What is differance betwwen Conventional MCC & Inteligent MCC?

2 Answers   Quantum, Siemens,

---

does a DG set has low fault level as compared to that of a transformer.If yes then why.

0 Answers  

---

Is it possible to measure the voltage of a battery from a single terminal?

0 Answers  

---

what you mean by frequency of an igbt& how to find it?

1 Answers  

---

What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?

0 Answers   ABC, Reliance Life Sciences, TCS,

---

2. What are the parameters of EHT sub-station?

0 Answers   APGenco,

---