Answer / cksahu `bpsl`jsg

total power gen. in india 165000

Answer / sathiyamoorthy

164,835.80 MW.

Answer / daisy

as on 31-1-2011
its around 1.7 lakhs mw

Answer / kamal karnatak

167317 MW till 2010

Answer / xyz

The electricity sector in India had an installed capacity of 205.34 Gigawatt (GW) as of June 2012, the world's fifth largest.[1] Captive power plants generate an additional 31.5 GW. Thermal power plants constitute 66% of the installed capacity, hydroelectric about 19% and rest being a combination of wind, small hydro, biomass, waste-to-electricity, and nuclear. India generated 855 BU (855 000 MU i.e. 855 TWh[2]) electricity during 2011-12 fiscal.
In terms of fuel, coal-fired plants account for 56% of India's installed electricity capacity, compared to South Africa's 92%; China's 77%; and Australia's 76%. After coal, renewal hydropower accounts for 19%, renewable energy for 12% and natural gas for about 9%.[3][4]

Answer / shubham

Around 250 Gw

Answer / shallu

331.5 GW IN OCT 2017

Answer / mukesh m gulhane

INSTALLED CAPACITY IN MILLIONS OF WATTS (megwatts)
TOTAL - 205340.2
THERMAL -136436.18
NUCLEAR- 4780.00
HYADRO - 39291.40
RENEWABLE ENERGY -24832.68

Answer / satya

1,55,000mw approximately

Answer / madhusudhana

1,25,000 MW approx

What is the difference between Derived earth Fault and measured earth fault.How it works.

1 Answers  

Why we are mention U1, V1, and W1 in primary side of transformer give technical reason

1 Answers  

What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?

0 Answers   HPCL,

what is th basic difference between a d latch time line and a d flip flop time line???

0 Answers  

iam completed my DEEE in eillm university. can i get the c licence in tamilnadu its possible or not

1 Answers  

how to calculate cable size in transformer, distribution side?

1 Answers  

why capacitor is not discharged phase to body

1 Answers  

how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design

0 Answers   Amara Raja, TATA,

What are the classifications of oscillators?

0 Answers  

why can't we provide dc supply to a transformer?

2 Answers  

To test Transformer we give HT side 440V to see wheather that it is producing 17.6V on LT to verify Voltage ratio is correct or not but when we give the 440V voltage to LT side then what will happen to HT voltage ?

3 Answers   Aditya Birla,

What are the safety equipments you should use while you are in a hvac switch yard

1 Answers   GPSC Gujarat Public Service Commission,