Answer / golshan

It is possible to build adder using decoders
But full adder has 3 inputs so you should be basically
using 3:8 decoder

The logic is simple for full adder there are 2 outputs -
Sum and carry
Now use the input of Full adder A B and C (previous carry)
as input to the decoder
Depending on the state of inputs the output line will be
either 0 or 1
now use a OR gate and OR the lines which have 1 output
during the desired state of inputs
apply the same for carry too

Answer / vivek

solution given by gulshan is correct

Answer / raghava

it should consist equal ratio,because the adder send 3 and
decoder gets 8 its not possible to increase the level.
so no solution according to this quetion.

What is the importance of valence shell and valence electrons?

0 Answers  

---

In which bands do the movement of electrons and holes take place?

0 Answers  

---

Explain what is an excitation table?

0 Answers  

---

What is delay angle or what is firing angle of phase controlled rectifier?

0 Answers  

---

what is Programmable logic controller?what is its importance and where itis used????

3 Answers  

---

when will give ta

0 Answers  

---

Explain the concept of frequency re-use.

0 Answers  

---

SIR VERY GOOD MORNING I AM APPERING FOR RRB EXAM FOR SECTION ENGINEER I REQUEST U TO PLZ FORWORD THE PAPER PATTERN AND EVEN PREVIOUS QUESTION PAPER SIR. I THINK U WILL SURELY HELP ME OUT IN EXAM.

4 Answers   RRB,

---

what is the difference between cdma and gsm

2 Answers  

---

Why clock frequency of microcontroller 8051 is11.059

2 Answers  

---

What is the differences between microprocessor and micro controller?

0 Answers  

---

is below 2 ohms earth resistance is good for mobile tower

0 Answers   Reliance,

---