why we use ac?why we use dc? why we we cannot use only
ac/dc for all the applications?what happen if we use?
- 0 Answers
- 1740 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
what is skin effect and why is it absent in DC systems
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
0 Answers TNEB Tamil Nadu Electricity Board, Vestas,
I Want randstand placement papers
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
What is the physical significant of power factor?
Which modulation has higher data rates a.fm b.am c.qam d.qpsk
How much KVAr bank reqired for 630 KVA transformer on full load for maintain power factor upto.99
4 Answers Dhanalakshmi Industries, DLF,
Explain the working principle of Synchronous Generator and Assynchronous generator?
why ht line fuse wire is so thin
what is the basic principle of the alternator ????
what are the causes for strip heater failure ?
How to maintaine ht motor efficiancy
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
