Follow Our FB Page << CircleMedia.in >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...

wat are the transmission losses.... how can it be
compensated.......
wat s power system.......

wat are the transmission losses.... how can it be compensated....... wat s power system.........

The transmission losses is the diffrence between the Actual
load is transfered from Generating station & the quantum
of energy received at the receving sub station . this
losses is because of the I^2* R losses of the conductor for
transmission. & also the Copper & Iron Losses in the
transformer side. This losses can not be get down to zero
but can be reduce Eddy current losses in transfomer by
using thin lamination & at the transmission end by using a
High voltage transmission because as the voltage is high
the curret will be low & also the losses.

 Is This Answer Correct ? 5 Yes 2 No

More Electrical Engineering Interview Questions

how do you calculate IKW(consumption per TR) in HVAC?

what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.

Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain

what is the difference between the 94 lockout relay and 86 lock out relay. I have noticed that the 94 lockout relay is activated when the distance realy is activated and 86 is activated when the 87T differential is activated. but why can't the same lockouts be used for both the protection schemes

I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.

In scott connected transformer number of turns in the primary winding of teaser transformer is % of number of primary turns of main transformer A 86.6 B 57.7 C 14.4 D 33.3

When Alarm report at LED,Alarm volatge is 11-13 Volt But LED is of 3 volt.then why not it burn?

Input power is 380 - 450 V but with 45 - 55 Hz frequency - desired output is 415 V and 50hz with 1% variation permissible. CVT / Servo dont stabilize the Frequency - what is best solution??

what is kvarh? Please difine it With calculation

What is the function of trip neutral close switch?

when the rheostat kept in minimum to maximum position in motors what will happen?

Are same transformer be employed for step up and step down services?

Categories
• Civil Engineering (5075)
• Mechanical Engineering (4444)
• Electrical Engineering (16600)
• Electronics Communications (3915)
• Chemical Engineering (1092)
• Aeronautical Engineering (214)
• Bio Engineering (96)
• Metallurgy (361)
• Industrial Engineering (258)
• Instrumentation (2987)
• Automobile Engineering (332)
• Mechatronics Engineering (97)
• Marine Engineering (123)
• Power Plant Engineering (170)
• Textile Engineering (575)
• Production Engineering (0)
• Satellite Systems Engineering (106)
• Engineering AllOther (1377)