Answer / nehru

I m ECE student but ECE student can do every technical job...
In IT side hardware used consist of IC's & other electronic
devices so for there development and maintance IT company
always required an electronic engineer.

Answer / gaurav jain

Electronics and Communication deals in different field like
Hardware (Design and Manufacturing), Software/IT (Embedded
system, MATLAB), Communication (Telecommunication) and
networking so candidate of ECE and choose any field among
these field as per interest and software is also a part of
ECE curriculum so its fair from ECE side to look for IT job.

Answer / anthony p

The communications field is rapidly leaning towards
networking for local communication between equipment.
Motorola, Kenwood, and other major brands are migrating
their engineering toward utilizing this faster proven
ability.
Repeater sets now communicate on a LAN basis, and have the
ability to perform phone calls over VOIP, instead of
integrating a modem and connecting to a phone line.
Remote sites can utilize this on 2-way radios, and send the
information to other sites via point-to-points. (microwave)
New advances in technology will require comunication
engineers and technicians to know networking protocols and
link different sites together to enhance coverage.

Answer / amit ghosh

when i choose this stream, i had no much knowledge about
this stream,but after persuing this branch i felt that that
i've so much interest on software. and as i am flexible so
i'm cent % sure that i a fit for any job ,because i do
every job by giving best of mine

Answer / jayaprabhakaran.k

though ihave done ECE i am not that much strong in
that,because my preparations were in exam point of view ..i
have done done a couple of software courses as part time i
beleive i can do it....

numerical aperture

1 Answers   ONGC,

why the input resistance of an op-amp is high whereas it's output resistance is low?

11 Answers   IBM,

What are the control strategies of chopper?

0 Answers  

what is the difference between electrical and electronic choke.. and whats the main advantage of elecronic choke?

0 Answers   Nestle,

A signed no is stored in 10-bit register, what is the max and min possible value of the number.

6 Answers   Cadence,

why dont call datareader is backward

0 Answers  

What is input offset voltage?

0 Answers  

Why the current in power diode varies linearly rather than exponentially with voltage?

0 Answers  

what are components used in LED message display board

2 Answers  

Explain what is meant by saying at what current is transistor biased?

0 Answers  

How can i display output voltage of my Power supply(DC) on the seven segment display ?? which IC is used?

0 Answers   BEL,

brown out function in micro controller?

1 Answers