Answer / mohit

1)it should be locaed at load center so tht losses can be
minimized
2) to minimize the voltage regulation

exact difference between electronicsand electrical

5 Answers  

---

why is that a 4*4mm cable,is always powdered internally

3 Answers   Construction, L&T,

---

what is the rating of a power transformer?

1 Answers   ACME,

---

Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.

0 Answers   HAL,

---

Dg daily a check duration

5 Answers   AirIndia,

---

what is the meaning of ceiling voltage in Generator exciter?

1 Answers  

---

can we coorect P.F. OF 320 KVA ALTERNATOR AT LOCAL SITE WITH RATED .8 PF LAGGING.

1 Answers  

---

71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit

0 Answers   Machino,

---

1.WHAT IS A SMART CAPABLE DB ( DISTRIBUTION BOX) ? 2. HOW TO DECIDE THE TYPE OF DB TO BE USED ( RECESSED/ PLUG TYPE/ SMART ETC ETC? 3. WHAT IS MILLENEUM BUS BAR USED IN DB? 4.DIFFERENTIATE MCCB AND MCB.

0 Answers  

---

Why indicate only 440V to 3-phase supply.

4 Answers  

---

How much width of the land shall have to be left below the EHT line of 440 kv as per the rule. i am told that a corridor of 35 M width is to be left free below 220 kv line. please confirm

1 Answers  

---

What is the function of induction motor when low voltage is apply.

6 Answers  

---