bullet proof glass is made up of which material?

Question Posted / sudhi

1 Answers
11406 Views
TCS, I also Faced
E-Mail Answers

bullet proof glass is made up of which material?..

Answer / sandeep

Bulletproof glass is usually constructed using a strong but
transparent material such as polycarbonate thermoplastic or
by using layers of laminated glass. The desired result is a
material with an appearance and light-transmitting behavior
of standard glass but offers varying degrees of protection
from small arms fire.

The polycarbonate layer, usually consisting of products
such as Cyrolon, Lexan and Tuffak, is often sandwiched
between layers of regular glass. The use of plastic in the
laminate provides impact-resistance, such as physical
assault with a hammer, an axe, etc. The plastic provides
little in the way of bullet-resistance. The glass, which is
much harder than plastic, flattens the bullet and thereby
prevents penetration. This type of bullet-resistant glass
is usually 70-75 mm thick

Is This Answer Correct ?

24 Yes

3 No

Post New Answer

More Mechanical Engineering Interview Questions

What is a combination thrust and radial bearing?

0 Answers

While selecting a diameter of 1 inch which pipe is better, ERW or Seamless ?? OR Out of ERW and Seamless which one gives good results for an impact force of 2700 N??

1 Answers

State the purpose of air heater?

1 Answers ABC Inc, RRB, Siemens,

what is the meaning of rheostat in maximum and minimum position?

0 Answers

What is the effect if tour refrigeration system has an air?

1 Answers RRB,

In a Waste heat recovery boiler feed control valve is after the economiser where as in auxilary boiler feed control valve is given before the economiser.why?

2 Answers

Explain what meant by Transmissability in Vibration ?

0 Answers

What will be expected the cut-off of J.E Mechanical exam of RRB on 19/12/2010 ?

0 Answers

hi please send the exam modle paper for mechanical engineering. Iam attending for vizag steel plant MT

0 Answers

what will be the velosity of a water at in the pipe of 6 inches which is situated at the bottom of 10 mtr tank ?

1 Answers Essar,

how to masure rake or helix angle of drill ?

0 Answers

What are the causes of low compression in the main engine?

0 Answers

For more Mechanical Engineering Interview Questions Click Here