Answer / Bhanu Pratap Singh Chauhan

Respiration is considered an exothermic reaction because it releases energy in the form of heat. During cellular respiration, glucose molecules are broken down, and the chemical energy stored in these molecules is released as ATP (adenosine triphosphate) and heat.

What is a good device to use for obtaining viscosity data for a non-newtonian fluid?

1 Answers  

---

Explain why is a vacuum breaker used on shell and tube heat exchangers that are utilizing steam as the heating utility?

1 Answers  

---

Water flows through a pipe with circular cross sectional area at the rate of V / t = 80 L / s where V is the volume and t is time. Let Av = 80 L / s where A is cross sectional area and v is velocity of fluid. For point 1, the radius of the pipe is 16 cm. For point 2, the radius of the pipe is 8 cm. Find (a) the velocity at point 1; (b) the velocity at point 2; (c) the pressure at point 2 by using Bernoulli’s equation where P Rgy 0.5 RV = constant. P is the pressure, R = density of fluid, V = square of fluid’s velocity, g = gravitational constant of 9.81 N / kg and y = 2 m = difference of height at 2 points. The pressure of point 1 is 180 kPa.

1 Answers  

---

When an expansion is joint needed on the shell side of a shell and tube heat exchanger?

1 Answers  

---

How to calculate the quantity of steam lost due to pinhole leak in a steam line of known pressure and line size?

1 Answers   CPCL,

---

why PH scale range is 14? why it is not less or not greater than 14? solution of HCl or hydrogen containing liquid has a PH. but if the solution is KMnO4 here not hydrogen power does it PH? explain plz....

1 Answers  

---

The power required for size reduction in crushing is???

5 Answers  

---

Are there any special considerations to be taken into account for combustion ammonia?

1 Answers  

---

What is % of piping & equipment cost for a chemical plant having batch process?

1 Answers  

---

Can condensate control in a reboiler cause water hammer problems?

1 Answers  

---

What is a good method of minimizing shell side pressure drop in a shell and tube exchanger?

1 Answers  

---

What is a common failure mechanism for above ground atmospheric storage tanks?

1 Answers  

---