We have two Al.busbars each of size 125mm*10 mm connected in parallel.To increase the current rating ,can we connect third busbar of size 100mm*10mm in parallel to existing two busbars?In my opinion ,if we connect busbars of different sizes in parallel,then the busbar of lowest size will take much current.So this type of paralleling should be avoided .Am I correct?

1 Answers   PDP Steel,

---

What is difference between PVC cable & XLPE cable?

14 Answers   Intertek,

---

What is the difference between multimeter

0 Answers  

---

what is ps impedance test

0 Answers  

---

In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??

0 Answers  

---

How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.

0 Answers   Cesco,

---

Why an ac solenoid valve attract the plunger even though we interchanges the terminal? Will the poles changes?

0 Answers  

---

how brushless dc motor is operating ?

4 Answers  

---

What is the simplest formula to calculate the rotor diameter of a synchronous generator?

0 Answers   PEI,

---

how one can design armature winding bothh front and back connection

1 Answers  

---

why co incidence factor considered in transformer sizing?

0 Answers  

---

How big (size) can the tertiary winding be in transformer? Can we load the tertiary winding, if yes then how much we can load it?

1 Answers  

---