In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
No Answer is Posted For this Question
Be the First to Post Answer
we can stepdown the voltage from 230/12v ,and we use the voltage for various electronics components why can't we step up the voltage from 12/230v if we can shall we use the voltage for domestic single phase supply
What are the necessary components of the feedback control system?
what happenes if two voltage source connected in parallel will be connected to load.
What happen if you keep open the Neutral Grounding Switch in open condition of the HT Generator at starting and again on load if it open then?
what is mean by busbar and what is the difference between busbar,transmissionline,feeder,distribution line
How to check the Bushings of the transformer?
What is the meaning of 'A synchronous motor floating on line'?
sir, is there any ratio,this much of A.C volt is equal to D.C voltage
I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN
What is the purpose of SSVW, IOVW, DVDF Tests in transformer? Those who are answering, pls send mail ids also.
why receiving end voltage increases in a system when capacitive load is added
how to calculate single phase motor efficiency ?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)