Answer / Jiggyasa Sonker

The phase crossover frequency is a point on the Bode plot where the phase angle of a system changes from lagging (phase shift > 0 degrees) to leading (phase shift < 0 degrees). In other words, it's the frequency at which the magnitude of the phase shift equals -90 degrees.

Which power will flow first if we switch on a motor Active or Reactive? How?

4 Answers  

---

how to minimize earth resistance upto 2&#937;, if the resistance is 6 &#937; ?

1 Answers  

---

why star connected transformers used in tneb?

1 Answers  

---

What is application of isolation transformer & How it works.

2 Answers   BARC,

---

What is chopper

1 Answers   Enercon,

---

Our Alternator nameplate specifies a power factor of 0.8. When the Alternator is on light load, the bus bar voltage rises to 11240 volts, whereas the standard value is 10500 volts. Is it ok to increase the power factor to 0.85 or 0.9. I am afraid because the power factor on the name plate is only 0.8 ?

3 Answers   Escube,

---

is it possible to flow currnet between earth and nutral wire in a circuit???

2 Answers  

---

what should be 3phase motor capacity or rating to connect in star connection. what should be 3phase motor capacity or rating to connect in delta connection. what should be 3phase motor capacity or rating to connect in star delta connection

1 Answers  

---

What is proximeter? where it is used and why?

1 Answers  

---

What are differences between Voltage, EMF & Potential difference ?

1 Answers  

---

how can electricity is produced without water

6 Answers   Bescom,

---

Why does the power consumed is always constant even if a fan speed is altered?

5 Answers  

---