Answer / priyanga

electronic device use less current but electric device use
more current. electronic device are preffered than
electrical device.

Answer / md. nazmul hudda

Electrical deals with high power, high voltage, high
current,conductor,low frequency,bulk equipment.

But Electronics deals with low power, low voltage, low
current, high frequency, semiconductor.

Answer / yugandhar reddy

electrical deals with high voltage & high current.
but electronics deals with low voltage & low current.

Answer / prashant kunal

mainly it is very contradict question .electronics comes from electrical .it is a part of electrical. In electrical we deals with mainly small frequency (50 hz)& high voltage (220 volt) but in electronics we deals with higher frequency and low voltages(5 volt). in electrical we used mainly for transmission of power (high power)power is taken into consideration so mainly cu wire is used for transmission but in electronics field is used for power transmission(bcoz power loss is less due to less power).

Answer / aromal victor

Electrical is the Subject that deals with Analog circuits and current.

Electronics is the Subject that deals with Digital circuits and current (0's and 1's)

That's all !

Answer / asad

THERE IS A DISTINCT DIFFERENCE BETWEEN THE TWO

ELECTRICAL ENGINEERING IS USUALLY POWER BASED AND
ELECTRONICS IS
PURELY A FUNCTIONAL BASED DISCIPLINE

Answer / chalam tirunagari

electrical is the study of current flowing through the
motors ,generators etc.
electronics is is the study of current flowing through the
diodes,resistors and capacitors etc.

Answer / ravi

Electrical is basically generation,tranmission,distribution
which is by means of A.C supply
Electronics is the utilisation part which with d.c supply

Answer / vini

Electric circuits are connections of conductive wires and
other devices whereby the uniform flow of electrons
occurs.
Electronic circuits add a new dimension to electric circuits
in that some means of control is
exerted over the flow of electrons by another electrical
signal, either a voltage or a current.

Answer / arshad

electronics is the study of steady charge while electrical
is the study of charge in motion

what is use of substation? Any book on how to instal or construction of substations?

6 Answers   Siemens,

How vfd saving power.

0 Answers  

help me with the question that might be ask on the interview for technical position

0 Answers   Eskom,

What is difference between slip rings and carbon burushes?

2 Answers   Hyundai, IVRCL,

1.what is surge used in power system 2.what is switching used in power system 3.what is lightning used in power system

1 Answers   Areva,

what are the specifications for Dc cables of higher rating

1 Answers   Reliance,

need of capacitor used in plant

3 Answers  

11 kV line deraction check by an Engineer.

0 Answers  

what is the difference between neutral and earth?

2 Answers  

i have applied for the post of RRB section engineering chennai board please send me previou papers and solved answer. my mail id jagarapusrinivas@gmail.com

0 Answers   RRB,

please send me privious exam's queation papers of section engineer(electrical).

0 Answers   RRB,

iii) A shunt motor runs at 70 rad/sec from a 460V supply and takes in an armature current of 100A. Resistors of 2.52 ohms and 1.64 ohms are connected in series with the armature and in parallel with the armature respectively. The field excitation remains direct from the 460V supply but the generated torque is halved. Determine the new running speed. Neglect brush voltage drop. The armature resistance is 0.4 ohms. [15]

1 Answers