Answer / ramkrishna sarker

Hi,
I think Electronics is an update version of Electrical.For example we used tube light they need time to on and was not comfortable with voltage.Sometimes they would fused but now here we use electronics device so they have a voltage range and take no time to on and less affected by voltage.

Answer / gia

electrical basically deals with the conductors and electronics deals with semi conductors . electrical deals with high voltage n current flow were as electronics deals with low voltage n current flow in a controlled manner

Answer / syed muhammad ahmed wasti

Electronic engineering involves the design and testing of
electronic circuits that use the properties of components
such as resistors, capacitors, inductors, diodes and
transistors to achieve a particular functionality. The
tuned circuit, which allows the user of a radio to filter
out all but a single station, is just one example of such a
circuit. Another example (of a pneumatic signal
conditioner) is shown in the adjacent photograph.

Answer / rajeshkumar

Electrical means flow of electronics through the conductors.

Electronics means flow of electronics through the
semi-conductors and vaccum.

Answer / niwas

electronic deals with component but electrical is the
source which drive the component.

Answer / karthi sekkappan

the branch that deals with controlling the flow of electron
by applying electrical signal is called electronic science

the branch that deals with flow of electron is called electrical

Obviously from above definition electronic is a branch of
electrical science

Answer / geetha

electrical deals with the transfer of the information through the electricity where as electronics deals with the transfer for the energy through electricity.

Answer / devi reddy baji reddy

electrical is only deals with linear elements like resistors,inductors and capacitors
electronics deals with non linear elements like diodes,transistors

Answer / srikant das

electronics based on electrical.

Answer / vineela

electrical doesn't have power amplification.
electronic may or may not have power amplification

I'm looking for a manual set for a Credence ASL-1000 or ASL 3000. Softcopy would be preferred but I'll take what I can get.

2 Answers  

what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?

0 Answers  

two transformer connected in parallel.tap change are different.if i want to on the buscoupler what happen?

1 Answers   Essar,

what should we do when the CT secodary gets open? how do we short circuit it? using tester or screw driver? not dangerous?

6 Answers  

WHWT IS USE OF VACCUM CIRCUIT BREAKER

4 Answers  

how much load 15kva dg set can bear

7 Answers  

how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .

0 Answers   Birla,

What is the field weakening mode of a ac motor?

1 Answers   L&T,

xpression 'document.FrmQF.myemail' [

0 Answers   ABB,

What will be cross section area of copper conductor for carry 2000 amps & 2500 amps....sq.mm.?/

3 Answers  

why voltage is low at reciving end in summer??

4 Answers   JSW,

why the power factor is low at no load?

1 Answers