what is the difference between electrical & electronics
- 245 Answers
- 302981 Views
- Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS, I also Faced
- E-Mail Answers
Answer Posted / syed muhammad ahmed wasti
Electronic engineering involves the design and testing of
electronic circuits that use the properties of components
such as resistors, capacitors, inductors, diodes and
transistors to achieve a particular functionality. The
tuned circuit, which allows the user of a radio to filter
out all but a single station, is just one example of such a
circuit. Another example (of a pneumatic signal
conditioner) is shown in the adjacent photograph.
| Is This Answer Correct ? | 38 Yes | 40 No |
Post New Answer View All Answers
HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)
I want to know how to calculate the size of electricity cable in building?
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
What is tranformer differtial?
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
which type of motor is used in automatic swing gate
how invertor convert the dc into ac give brif detail
What is VCB? where it is installed at SP. What is SP?
1)we have 1000 cfm Blower,Dia-1Mtr,Velocity of air 94 m/s 2)We have Natural Air velocity 94m/s 3If i Put Wind Mill in natural air ,speed is 94m/s Then it will generate Assume 100kw 4)If i put same wind mill across the Blower,air speed is same 94m/s now the Question is Will it generate 100 kw?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
How can we calculate the transformer rating if the load calculated is 1000KW (11Kv Supply)?
What are the advantages of vscf wind electrical system?
how can we select the appropriate VCB ?
Can anybody post questions asked in Engineers India Limited Interview? Thanks in advance.
