What is line resistance of cable & how it can be measured ?
No Answer is Posted For this Question
Be the First to Post Answer
1-What is the difference between absorption factor and polarization factor in insulation resistance test in transformers? and why we inject until ten minutes to get polarization factor?
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
what is the resultant phase shift in a 3 phase power system including neutral if on or more phases gets grounded or short circuited. kindly explain in detail for the reasons...
In electric motors, according to the no. of compartments, The no. of input's (pantagraph collector's) were increased, why?
Natural frequency in the control system represents nature of a. Transient response b. Oscillations c. Overshoot d. Speed of responce
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
how can we determine size of a cable by knowing the kw or current rating of a load?how can we calculate the resistance box of a slip ring motor?
if receiving voltage is higher than sending ones what will be the effect of receiver
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
Electrical breakdown strength of an insulating material depends on............?why because?
what is the reasons for blowing fuse
Active power= VI COS FI But incase of leading power factor ( more than unity), may we use other formula ? because the cos fi (value of cos thita) should not be grater than one.