Interested to Buy Any Domain ? << Click Here >> for more details...
For the second gear in a synchromesh system, the drive transfer will be through
a) U1, U2, C, F2, and splines
b) U1, U2, C, F1, and splines
c) U1, U3, D, F3, and splines
d) U1, U4, U5, E, F2, and splines
- 0 Answers
- 1366 Views
- Backbone, Bosch, MAHINDRA, Uniparts Group, I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
What is the size of the recommended compressor cfm? Where it can be used?
What is standard size journal and big end crankshaft in mahindra bolero
What size of a compressor (cfm) is recommended for the purpose of inflating car tyres, spray painting, etc.?
why tractor rear wheel is big then front wheel
what is balancing?
1 Answers CFB, Global Automotive Research Centre, ITI, MAHINDRA, Shriram Pistons Rings,
Which mechanism is used in automobile gearing?
Where is fan located in car?
automobile
Tell us about the working of a 6-stroke engine.
What is the approx. temperature at the spark plug at the time of ignition??
Due to drive torque, what is transverse weight shift?
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
