Answer / kangchuentat

Answer 85 - (a) From I as origin, J - I = 8 %, K - J = 10 %, K - I = 18 %, then I ... 8 % ... J ... 10 % ... K. (b) There are 22 genes between b and y, separated by 3 % recombination between 2 adjacent genes. Percentage recombination between b and y = (22 + 1) x 3 % = 69 %. The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.

Explain how can you determine the largest impeller that a pump can handle?

0 Answers  

---

What are some common causes of control valve noise?

0 Answers  

---

Chemical Engineering Energy Balance - Please match the term A - E as follow with the stated definition : A. Yield. B. Selectivity. C. Relative saturation. D. Molal saturation. E. Absolute saturation. i. Answer : ? (moles of desired product formed) / (moles that would have been formed if there were no side reactions and the limiting reactant has reacted completely). ii. Answer : ? (moles of desired product formed) / (moles of undesired product formed). iii. Answer : ? (relative humidity 40 % means partial pressure of water vapour equals 4 / 10 of the vapour pressure of water at the system temperature). iv. Answer : ? (moles of vapour) / (moles of vapour dry gas). v. Answer : ? (mass of vapour) / (mass of dry gas).

1 Answers  

---

Where the Induced draft, forced draft & balanced draft furnace are to be used? Selection of furnaces are based on which criteria?

0 Answers   IFFCO, MahaGenco,

---

why when we perform SCC of an alternator we always get a straight line even when 125% rated current is flown?

1 Answers  

---

---

What is the ignition temp. of Alluminium,Coper&Iron.

0 Answers  

---

Question 39 - Acetone and ethanol are separated using a distillation column with a partial condenser and partial reboiler. An equimolar, sub-cooled liquid feed enters at 100 kmol / hr and condenses 1 mole of vapor for every 6 moles of feed. The separation requires a distillate vapor that is 95 mol % acetone and bottoms liquid that is 5 mol % acetone. The reflux is returned from the condenser to the column as a saturated liquid and the operation is run at (L / V) = 1.4 * (L / V) min. Assume constant overflow conditions. (a) Feed operating line is y = [ q / (q - 1) ] x - z / (q - 1) where z = 0.5 for equimolar liquid mixture of 2 components, q = (L’ - L) / F where L’ = L + F + (F / 6) for condensation of 1 mole of vapor / 6 moles of feed. What is y = f(x)? (b) The rectifying operating line is y = (L / V) x + (D / V) (xd) where (L / V) min goes through the points A (0.95, 0.95) and B (0.53, 0.69), V = L + D. What is y = f(x)? Let xd = 0.95. (L / V) min is the slope of the 2 points A and B.

1 Answers  

---

What is the difference between cfm (cubic feet per minute) and scfm (standard cubic feet per minute)?

0 Answers  

---

Which type of pneumatic control valve is used mostly Either Air to Open r Air to close the value And guys I need reason for your reason

0 Answers  

---

BIOCHEMICAL ENGINEERING INSTRUMENTATION - EXAMPLE 29.5 : The following formula is used as a reference : (analyte signal) / (internal standard signal) = (f-factor) x (concentration of analyte) / (concentration of internal standard). A solution containing 3 mM of analyte and 4 mM of internal standard gave peak signals of 2 and 3 mamps respectively. Another similar solution containing 2 mM of analyte and 1 mM of internal standard gave peak signals of 1 and 4 mamps respectively. Find the average f-factor.

1 Answers  

---

Explain what are the affinity laws associated with dynamics pumps?

0 Answers  

---

what are lubricants using in compression.

1 Answers  

---