Answer / jagan_srinivasan2002@yahoo.co.

100kgs/day/fitter

How will you provide reinforcement from corrosion?

2 Answers  

---

How will be cutting in timber plate size 600*400 column size

0 Answers  

---

what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)

0 Answers  

---

What is differences between torsion and buckling?

2 Answers  

---

General Knowledge 1. Which is the virus for SWINE Flu? Ans.H1N1 virus 2. Who is Paola Maino? a) Original Name of Sonia Gandhi. b) Mother Name of Sonia Gandhi c) An actress d) Christian Missionary 3. Who is Andy Moles? 4. Which state there is no scheduled caste seat for lok Sabha Assembly? CIVIL ENGINEERING 1. When was Indian road Congress (IRC) established? 2. What is the camber for Concrete Road? 3. What is the camber to be provided for Earth Road? 4. What is the ruling gradient to be provided for Plain roads? 5. What is the type of surveying to be used for deciding the alignment of hilly roads? 6. What is the condition on which Bernoulli law depends? 7. water is which type of fluid a)Newtonian b)Non- Newtonian c)Ideal d)Compressive 8. The law of continuity depends upon what factors? 9. In Plane Table surveying which is done first a) centering b)Leveling c)Orientation d)Centering and leveling simultaneously 10. Pavement width depends upon a)Type of terrain b) lane width c)Type of traffic 11. Which is costliest type of timber a) Sal b) Shish am c) Teak? 12. Which is timber used for making plywood a)Teak c) Bamboo fibers d)Common Timber 13. What is Veneering?

6 Answers   Vizag Steel, VSP,

---

what is the procedure to clean the mivan technically?

1 Answers  

---

how to distinguish TMT n Tor steel?

2 Answers  

---

I'm puting roof slab M20 Design Concrete,Twoway slab how many days wait for remooving of shuttering?

16 Answers  

---

What is Density of cement, sand & aggregate ?

0 Answers  

---

Why we select pile foundations

2 Answers  

---

how to decide the mortar ratio 1:4,1:6 in masonry? same in plaster 1:3 and 1:4? which code or any document reference taken to define proportion?

0 Answers  

---

What do you mean by TOLERANCE in steel

1 Answers  

---