i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?

0 Answers   QAFCO,

---

For a diafhram 1.5 d =kn(p-p0) D4 Where d in deflection in inch k=constant n=no of capdule (P-P0)=Applied pressure in psi D In active dia at capsule. -1.5 d=k to p d being constant -1.5

0 Answers   L&T, Shiv Tech Marine Control,

---

what is bevel? why bevel required in orifice plate?

2 Answers  

---

what is IEC code in cables & how to selecting cables?

0 Answers   ROS,

---

what happens when the profibus fails while in operation (operation of a valve)?

5 Answers   L&T,

---

---

Tell me about the synchronization panel.

1 Answers  

---

Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---

can we change the range of 3151 model level transmitter of rosemount make? present calibration range is 1000mmwc and want to change it to 2000mmwc

4 Answers  

---

What is mean by analytical instrumentation?

0 Answers  

---

How to Calibrate Ultrasonic flow Transmitter in Field

0 Answers  

---

What is frequency factor in massflow meter? When using frequency output?

0 Answers   PCMIL,

---

Why we are using thrust bearing at turbine side?

3 Answers   Edac,

---