Answer / syncopator

To be used as a switch, a transistor will be either not conducting and therefore be an open switch, or fully conducting (in saturation) and therefore be a closed switch.

To be an amplifier a transistor has to have a standing bias such that it is operating in its linear mode.

CAN A GSM MOBILE TOWER ESTABLISH WIFI FACILITY?

2 Answers  

---

WHAT IS THE USES OF PLC?

16 Answers   Avanceon, BMW, Sony, Usha Martin,

---

What precautions are required to be observed in the use of leds?

0 Answers  

---

Explain the approximate cost of the corrosion penetration monitoring system(cpmp)?

0 Answers  

---

Why is collector region is greater than emitter region?

0 Answers  

---

What is the work of BOIA, TRx, BB2F, Duplexer, Combiner, Multi-coupler, RRI.

0 Answers   NSN,

---

What are the test parameters to check the proper functionlity of TCP/IP protocol.

0 Answers   Infosys, Mind Tree,

---

what is ISDN 1:2or 1:8 ? what is bandwidth allocation? how to the design small network with 4 router?

0 Answers   CMS,

---

In a bipolar junction transistor (take it an n-p-n BJT),,in comparison between EMITTER and COLLECTOR ,,who has higher negativity??

3 Answers  

---

Define virtual ground in the op amp?

0 Answers  

---

if a crow sit on on current wire it will not fell current but a man touch it he get shock . why/

4 Answers   Asianet, HCL,

---

realize a not gate from an xor gate

1 Answers   Tech Mahindra,

---