What will happen if we rotate the horizontal plane in anti-clock wise instead of clock wise and make the drawings in 2nd and 4th quadrant?Why the horizontal plane always rotates in clock wise?
Answer / rahul k barnwal
The top view and front view will be on the same side as the two plane will overlap each other.
As we know that f.v and t.v on different sides emerges on 1st nd 3rd quadran,so we rotate the horizontal plane in clockwise direction.
Is This Answer Correct ? | 0 Yes | 0 No |
The graphite in grey irons exists in the form of flakes which act as stress-raisers under tensile loading and consequently grey irons have relatively low tensile strength and ductility. Still grey iron is extensively used in engineering. Why ?
How does a boat measure speed?
Explain the types of sensors and their explanation?
What type of pump is commonly used is feed water system in boiler?
what is viscosity?
Can i get technical questions asked in ADANI Power?????
2 Answers Adani, Adani Power, GJ,
Dear Sir, Please send me the questions frequently asked during bhel persoal interview for supervisor trainee With worm regards, Alok Kumar Rout e-mail id- rjdalok22@gmail.com
effect of temperature on stainless steel at temp(500C-750C) in respect of the following properties-required for silencer application 1.thermal conductivity 2.heat conduction 3.mechanical strength 4.temperature to weight ratio with values
what is 5 element level controller using in boiler.
How to stoped water tube boiler
what is the diffrence bitween hypo eutectoid and hyper eutectoid steels?
6 Answers Bhel, Suzlon, TATA, Tech Mahindra,
why we transfer FA(full arc) to PA(partial arc) in steam turbine at specified load?