Answer / Archana Singh

To check DG On Load, DG On Load Alarm, and Piu Alarm in electrical systems, you would typically refer to the system's manual or schematics for proper testing procedures. These alarms are often indicated through visual or audible signals on the device or control panel, or by monitoring system parameters such as voltage, current, or power factor.

hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible

0 Answers   Engineers India, Engineers India Limited,

---

what is the purpose of ignitor in lighting fixer

1 Answers  

---

Why use the vcb at high transmission system ? Why can’t use acb?

1 Answers  

---

When color of silica gel will gets change from blue to pink from Top to bottom?

1 Answers  

---

How much minimum insulation required between 11kv/3.3kv transformer windings?

0 Answers   Descon,

---

how to discharge 3 phase power factor correction capacitors

1 Answers   M S Ramaiah Institute,

---

1. name the relay for protecting transformer 2. Current Transformer 3. potential Transformer

1 Answers  

---

What is meant by SMPS how it working ... and where it used

2 Answers   MTS,

---

can we load Power capicitors on DG sets?

14 Answers   Neptune, Nimbus, Westin,

---

What is the value of system voltage?

2 Answers   Bhel,

---

DC transmission

1 Answers  

---

what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?

1 Answers  

---