basic difference between bsIII & bs IV

Answers were Sorted based on User's Feedback

basic difference between bsIII & bs IV..

Answer / mukesh vaishnav

the engine of cars were according to the BS-III norms, but after that all the new cars manufactured are as per BS-IV norms which is stricter engine emission norms . These norms make the engine give good mileage with little carbon fumes and are silent too, so the new engine is more eco friendly than the older ones. And i guess every city has different norms requirement when you buy a new car.

Is This Answer Correct ?    0 Yes 0 No

basic difference between bsIII & bs IV..

Answer / venkat

In BS-lll engine compared to BS-lll engine only difference is emissions control I.e NO,CO and HC are less in BS- lll engines and BS-lll has turbocharger with intercooler.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Automobile Engineering Interview Questions

The resistance to the vehicle motion whose magnitude various with the square of the vehicle speed is a) Resistance due to gradient b) Resistance due to road c) Resistance due to the tyre friction d) Resistance due to wind

0 Answers   Bosch, MAHINDRA, Backbone, Uniparts Group,

In a constant mesh gear box, when the right dog clutch is engaged with the gear on the right side of the main shaft, a) Direct gear is obtained b) First gear is obtained c) Second gear is obtained d) Reverse gear is obtained

0 Answers   Bosch, MAHINDRA, Backbone, Uniparts Group,

In a synchromesh device, when members G1 and F1 are slid to left and cones M1 and M2 are in contact, a) Direct gear is obtained b) Second gear is obtained c) Third gear is obtained d) Reverse gear is obtained

0 Answers   Bosch, MAHINDRA, Backbone, Uniparts Group,

What purpose to use damper pulley to engine?

1 Answers   Toyota,

i had applied for 6 categories for rrb section engineers posts 2 different rrb boards 2 those i was eligible of an single notificatoin. do i need 2 write different exams or single exam

0 Answers   RRB,

most popularly used gas,characterestics,applications,features

0 Answers  

why we are using oil with petrol in two stroke engines but not in four stroke engines(two wheelers)?................

11 Answers   GE, MAHINDRA, Ford,

why do cars have smaller tyres and bikes bigger ?

4 Answers   Hero Honda, Ford,

what is the product of tata company

3 Answers   TATA, Tata Motors, Tata Steel Limited,

If the given tractive effort curve and the total resistance curve does not intersect, then a) The vehicle will accelerate b) The vehicle will decelerate c) The vehicle will not be able to go at this gradient for the given gear d) None of the above

0 Answers   Bosch, MAHINDRA, Backbone, Uniparts Group,

For the purpose of inflating car tyres, spray painting, etc. i.e. say a small workshop, what size of a compressor (CFM) is recommended? It will be generally for a hobby use and not commercial use.

1 Answers  

What are your Future Plans for company

2 Answers   Volkswagen, GMT,

  • Civil Engineering Interview Questions Civil Engineering (4636)
  • Mechanical Engineering Interview Questions Mechanical Engineering (3700)
  • Electrical Engineering Interview Questions Electrical Engineering (15765)
  • Electronics Communications Interview Questions Electronics Communications (2636)
  • Chemical Engineering Interview Questions Chemical Engineering (762)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (79)
  • Bio Engineering Interview Questions Bio Engineering (30)
  • Metallurgy Interview Questions Metallurgy (95)
  • Industrial Engineering Interview Questions Industrial Engineering (199)
  • Instrumentation Interview Questions Instrumentation (2879)
  • Automobile Engineering Interview Questions Automobile Engineering (171)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (41)
  • Marine Engineering Interview Questions Marine Engineering (62)
  • Power Plant Engineering Interview Questions Power Plant Engineering (169)
  • Engineering AllOther Interview Questions Engineering AllOther (1334)