Answer / muhammad jehangir afridi

If the suction pressure at the eye of the impeller falls below the vapour pressure of the fluid bei at the ng pumped,the fluid will start to vaporize.
Any vapour bubbles formed by preessure drop at the eye of the impeller are swept along the impeller vanes by the flow of the fluid.when the bubbles enter a region where local pressure is greater than saturation pressure farther out the impeller vane,then the vapour bubbles abruptly collapse..this phenomena is called cavitation...
It creates noise,vibration and damage to many of the components, a loss in the pump efficiency etc..

Answer / jerry casteel

Cavitation is when the pump is running but the product is stalled in the pump.

what is alignment of two shafts and procedure and how we have to give the correction for misalignment

5 Answers   Airtel, RRB,

---

1. Centrifugal pump is used to drain the coolant from the machine to coolant tank via magnetic separator and paper filter. But more foam is raising in the coolant tank. We need to arrest the foam formation inside tank which is nt desired. How do we correct this issue? (Hardness of the water is at recommended ppm).

2 Answers   Nissan,

---

On 22nd December, which of the following places has the largest day and shortest night ?

2 Answers  

---

when eating ice cream, why the spoon of wooden material is always straight & plastic spoon is always convex in shape?

5 Answers  

---

Explain the cycle of refrigeration system.

0 Answers   RRB,

---

one kg of gas is compressed adiabatically from 1 kg/sq.cm,1 cubic metre volume and 300 kelvin to 5 kg/sq.cm,0.5 cubic metre and 400 kelvin.work transfer in this process will be

0 Answers   MAHINDRA,

---

whats the range of poissons ratio of a stable material??

3 Answers  

---

What is meant by effectiveness?

0 Answers  

---

1.Describe a time when you anticipated potential problems and Developed Preventive measures. 2. Tell me about a time when you had to use your presentation skills to influence someone's opinion. 3. Tell me about a time when you had too many things to do and you were required to prioritize your tasks. 4. What is your typical way of dealing with conflict? 5. Tell me about a time you were able to successfully deal with another person even when that individual may not have personally liked you (or vice versa).

1 Answers   Chevron,

---

What is flash steam and flashing phenomena?

0 Answers  

---

How to decide the thickness of sheet metal while designing the bracket?

0 Answers   TATA,

---

Sir can u send me few interview questions and answers based on Deputy Superintendent(materials) of APSRTC. I have selected in written.reply to bhanudammoju@gmail.com thank u.

0 Answers  

---