Answer / gokul krishna g

Lap length addresses the length of the bar needed to transfer the stresses to the other bar
Development length addresses the length of the bar needed to transfer the stresses to the concrete.

What is the quantity of steel, cement, sand, and aggregate required for a 2100 sq ft Roof Slab(Residential Building) area of RCC?

1 Answers  

---

how to calculate the quantity of cement,sand and aggregate when the ratio of mixing is 1:2:3

0 Answers   Ajnara Group, Assosa University,

---

how many area req.in 15000liter water tank

7 Answers  

---

If a 12m main road straight is adjoined from both sides by 7.5 m road , how curves are given at corner for vehicle movement (measurement pls.)?

1 Answers   Sobha Developers,

---

How do I calculate the ground is resested for a 5 floor building?

3 Answers   L&T,

---

Cement Co-eff. in block 1:6, brick1:4 work?

2 Answers  

---

I need old MMUP exam question and answer for Civil engineering

0 Answers   MMUP,

---

Special thing in designing a overhead reservoir ? which is different from an ordinary design

0 Answers  

---

How to Rectify deep crack formed on Brick Wall? Explain the method of rectify the defect?

3 Answers   Coromandel,

---

how much cement sand n bricks required in im3?and how much in plaster?

0 Answers  

---

How much does it cost for a R.C.C cover slab of size (450mmX 600mmx 100mm) double rf net given in feets using hand mix concrete?

0 Answers   ADK,

---

whike making bbs we deduct 2d for every bend in bar but theoretically we cant subtract 2d for every bend and for every dia of bar , so plz tell me the exact deduction for bends for different dia of bars and for different angles ??

1 Answers   Sobha Developers,

---