Answer Posted / gokul krishna g

Lap length addresses the length of the bar needed to transfer the stresses to the other bar
Development length addresses the length of the bar needed to transfer the stresses to the concrete.

How to decide/consider the grade of bitumen for dbm.

2250

---

Does degree of bend of rebars has any effect on strength of the member? For example- if a beam is designed with 45 degree bent up bar with respect to architechtural needs and is not 45 in practical so will there be any reduction in the strength of member?

2118

---

Why are steel plates inserted inside bearings in elastomeric bearing?

1306

---

how many material required for brickbat water proofing of toilets.

2024

---

How many are the types of joints?

1198

---

explain five benefits of using standard terminology in the measurement process?

2167

---

I have an plot with area 35*47 = 182.77 sq yards. Out of this iam planning to construct house with 1350 sqfeet each floor .iwanted to build a G+2 house.Need cost estimation for each item

1938

---

What will you do if a portion of load bearing wall collapses under your supervision?

2001

---

Define What is diversion tunnel in a dam?

1289

---

What tor stands for in tor steel?

1083

---

please send me bhel questions on rupesh.017@rediffmail.com

2705

---

i want to ecil (Electronics Corporation of India Limited Hyderabad) previous civil engineering question papers immediately please.............

3130

---

Explain what is structural frames or systems?

1149

---

what are the five benefits of using standard terminology in the measurement process?

2202

---

What should be the maximum allowable time for placing ready mix concrete? The specification requires concrete placement within 90 minutes of batching at the plant. What is the significance of this 90 minutes & should this be used as a rejection criterion? What effects does the concrete has after that time period?

2864

---