For a Vernier scale of representative fraction (RF) = 1 / 25, calculate the length of the scale for the reading up to 4 metres.



For a Vernier scale of representative fraction (RF) = 1 / 25, calculate the length of the scale for ..

Answer / kang chuen tat (malaysia - pen

Length of the scale = RF x maximum length of the scale = 1 / 25 x 4 x 100 = 16 cm. The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS 61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Chemical Engineering Interview Questions

have any one question paper of institute of plasma research center for aptitute as well as technical?

0 Answers  


what is the speed of a rotary drier

3 Answers  


ELECTRICAL TECHNOLOGY - EXAMPLE 16.3 : In the design of a solar power system steps of calculations below are followed : (a) The power output of the inverter of the solar panel is 100 watts. What is the power input, Pin to the inverter when the efficiency of the inverter is 50 %? (b) If the rated power of the inverter is 300 watts, how many inverter is needed for the solar panel? (c) Charge controller of V = 12 volts is used to supply power to the inverter. What is the input current I to the inverter? (d) If the charge controller capacity is 10 A, how many charge controllers are needed? (e) If a biochemical mixer consumes 100 watts, running for 2 hours per day, what is the energy consumption in kilowatt hour per day? (f) What is the input energy needed when the efficiency of the inverter is 50 %? (g) If your area receives 2.88 hours of full sunlight per day, how much energy, in kilowatt hour can be produced per day when one solar panel can produce 20 watts of power? (h) If you know that you have to produce total energy as the answer for (f), how many solar panels are needed? (i) Each V = 12 V battery has 5 ampere hours. If the total energy needed is in answer (f), then how many batteries are needed to run the biochemical mixer if without sunlight for 3 days?

1 Answers  


Explain what are the disadvantages of using gear pumps?

0 Answers  


i'm a chemical engineer with an aggregate of 80% and i'm going to attend for TCS next week...if i encounter a question like this how i have to answer... WHY YOU CHOOSE SOFTWARE RATHER THAN YOUR CORE COMPANIES?

0 Answers  






ENGINEERING PHYSICS - EXAMPLE 30.2 : The Planck-Einstein relation connects the particulate photon energy E with its associated wave frequency f to produce E = hf. Let h to be the Planck constant. The frequency f, wavelength L and speed of light c are related by E = hc / L. With p denoting the linear momentum of a particle, the de Broglie wavelength L of the particle is given by L = h / p. (a) Find the equation of E as a function of p and c. (b) If E has a unit of electron-volt and f has a unit of 1 / second, then what is the unit of h?

1 Answers  


what is cv value in valves

3 Answers   IFFCO,


Hi.. Me going to tke test for management trainee(technical) Post I am an chemical engineering student . Can u guide how to prepare for this test.Can u send me test paper pattern..?

0 Answers  


what are the chemicals used in PFR and MFR to Process?

0 Answers  


What step should be taken in process industries if the process variable is oscillating?

0 Answers   HPCL,


QUANTUM BIOLOGY - EXAMPLE 33.3 : In quantum biology, microtubule is used to store information in a cell. At temperature of T = 300 K, measured current I in a probe is directly proportional to the supplied voltage V, when passing through a microtubule with resistance R. (a) Form an equation of V as a function of I involving k as a constant. (b) If the microtubule has R = 1 ohm at such condition, find the value of V when I = 2 A. Hint : Ohm's law. (c) Find the relationship of k as a function of R.

1 Answers  


QUANTUM BIOLOGY - EXAMPLE 33.10 : The wavefunction starts out in a superposition of possible states in a closed black box like this : Ψ (kitty) = 0.7071 Ψ (alive) + 0.7071 Ψ (dead) where Ψ (kitty) = wavefunction of a kitten, Ψ (alive) = wavefunction of a living kitten, Ψ (dead) = wavefunction of a dead kitten. By prediction and calculation, find the probability of : (a) a living kitten inside the black box; (b) a dead kitten inside the black box.

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)