Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.
No Answer is Posted For this Question
Be the First to Post Answer
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
Does voltage and current can be seperated?
How can we calculate the rating of capacitor bank to be connected for a particular load(ex.100kw)to improve the power factor from 0.8 to 0.9?
What are the methods used to improve powerfactor ?
can we use only a isolator in the subtation..
differance b|w ground, neutral&earth
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
list the advantages of RCCB over other circuit breakers?
whats happen if we disconnect the NGR of alternator in running condition?. Generally we observed that transformer netrul is directly grounded but alternator connected with NGR, then ground?
How do ACB are maintenance, what are the problem occurred in ACB
What is the Difference between Power Swing and Out of Step?
Where voltage are high and current to be interrupted is low the breaker preferred is:
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)