Answer / mayur

66*66/400 = 10.89 approx. 11 MVA
where 66kv is a voltage level,
and 400 ohm is a surge impedance of overhead transmission line.

In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?

0 Answers  

---

What is difinition of HIGH RESISTANCE FAULT and LOW RESISTANCE FAULT?

3 Answers  

---

Where to use pt and where to use CVT

2 Answers  

---

What is the difference between grounding & earthing?

9 Answers  

---

The unit of quantity of electricity is the:(a) volt(b) coulomb(c) ohm(d) joule

1 Answers  

---

in a dc motor we supply current only to the armature conductors,from where is the field winding gets excited then??

3 Answers   RRB, Siemens,

---

If a 1.5V,3W torch light bulb is connected in series with a 15HP/11.19KW,230V single phase motor and the combination is connected against a 230V supply and switched on than what will happen keeping all other parameters as it should be A)the bulb will glow normally B)the bulb will not glow C)the bulb will glow with extra brightness D)the bulb will burn out and if a fuse is connected to the above circuit will something happen to the fuse and what about the single phase motor will it be affected? Please explain with derivation

4 Answers  

---

In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?

0 Answers  

---

what is the difference between diode and zener diode?

4 Answers  

---

What are the types of bus duct?

1 Answers  

---

what are the main differences of delta and star connection

5 Answers   Essar,

---

why do we use 3 single phase instead of one 3 phase?? though vee connection is its advantage but what is the hidden reason behind it??

2 Answers  

---