Answer / ankushkalia

notch is the device used for the measurement of the rate of flow of liquids through small channels at tanks where as orifice is used to measure rate of flow through pipes.

Answer / deep patel

An orifice is provided in side or the bottom of tanks to transfer the fluids. And generally, the upstream fluids occupy majority of area of orifice (neglected vena contracta) . Whereas, notches are provided on the side of the tanks to determine the flow rate of liquid. And generally the liquids in notches, do not touches the upper edges of notches.

what is mpa

2 Answers  

---

why we are maintain boiler ph 9.0,not maintain 10.0 or 11?

2 Answers  

---

what is the difference between clutch and gear ?

2 Answers  

---

State the laws of thermodynamics and its importance of in mechanical engineering.

0 Answers  

---

1.In modal analysis ,we can give damping or not? 2.draw goodman's rankine fatigue curve? 3.write down goodman's rankine fatigue equation? 4.IN structural analysis ,out of so many stresses,why von-mises stress are chosen?

1 Answers   Infotech,

---

how to control ovality in internal diameter

1 Answers  

---

what should be sensor sensitivity of accelerometer in vibration? And what is the main difference between accelerometer and proximity sensors and others?

0 Answers   Reliance,

---

why we use kg/cm2 instead of kg/m2 as a unit of pressure. As we know kg is a MKS unit and cm is a CGS unit. So why we use combination of both(kg/cm2)while describing the pressure.

3 Answers   IES, NTPC,

---

What is the purpose of I.O. circulation before and after starting of engine?

0 Answers   RRB,

---

what is a presure relife valve in a diesel generator.

2 Answers  

---

For hot water : please compare to solar heat and heat pump (environment/operation/invest...) Is there any comparison available. Thank you

0 Answers  

---

what is manufacturing cost of an aeroplane?

3 Answers   Jindal,

---