if we have a power factor 0.99 and we add a capacitive bank with it th

if we have a power factor 0.99 and we add a capacitive bank with it then what happen?

Question Posted / saqib

4 Answers
5464 Views
University, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

if we have a power factor 0.99 and we add a capacitive bank with it then what happen?..

Answer / vicky

Firstly depending upon the value of capacitor .The power factor value will become unity first and than moving the leading power factor region from lagging power factor region.
leading power factor is generally not advisable to operate

Is This Answer Correct ?

11 Yes

2 No

if we have a power factor 0.99 and we add a capacitive bank with it then what happen?..

Answer / huzy

The change depends upon the load and the values of the capacitor to be added. It will surely increase the PF but up to which extent depends upon the load and capacitor value.

Is This Answer Correct ?

7 Yes

1 No

if we have a power factor 0.99 and we add a capacitive bank with it then what happen?..

Answer / sajal keshri

if more capacitors are added with existing system then the leading power factor converted into lagging and cause for penalty in electricity bills,,,

Is This Answer Correct ?

1 Yes

0 No

if we have a power factor 0.99 and we add a capacitive bank with it then what happen?..

Answer / akash

It will show in minus mode(-).

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

in star delta starter current is 1/3times the delta value how?

2 Answers

May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?

0 Answers

what is the location of lighting switch of battery room

1 Answers

Fot testing new star-delta 132 kw motor in electrical worshop.we should check in star or delta connection as we do not have higher capacity cable in worshop?

4 Answers Adani,

WHAT IS ELECTRICAL MAINTAINTENCE ?

0 Answers

what should be distance between phase to phase in 415v system?

1 Answers NTPC,

if HT side voltage is high current is low . and LT side voltage is low current is high please explian.

5 Answers HP,

What accessories required to give the motor with given circuits and do you know the ratings of those accessories?

4 Answers Hyundai, TCS,

Simultaneous trip of incoming and outgoing breakers of 400kv/220kv trnasformer. What are the probable causes?

2 Answers

before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water

0 Answers

what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer

0 Answers

how can check the resistance of battery contact?

0 Answers Cipla,

For more Electrical Engineering Interview Questions Click Here