Answer / divusp

min 32.5mpa parallel to grain
min 22.5mpa perpendicular to  grain
sum not less than 60 Mpa

Answer / divusp

parallel to grain 32.5 mpa min
perpendicular to grain 22.5 mpa min
both add min 60 mpa(N/mm2)

what is the theoritical percentage of concrete cubes testing per day?

1 Answers   Fresher,

---

we have a crushing plant and our product is experiencing flakiness and elongation over limit for granite. what is the solution to this problem? how can it be avoided and what to do differently? It is not ok for batching plants

0 Answers  

---

if 20mm aggregate is coming by weight 25 ton in a 10 wheeler hywa ,then what will be total volume of aggregate in cubic feet.

0 Answers  

---

beam is fixed at both end which is 8 m span carry udl of 10 kn/m at left half span.there is internal hinge at center.what is reaction at center

1 Answers   IES,

---

what"s the cement, sand, aggregate(consumption) quantity for 10 cm thick roof slab (1:2:4)

0 Answers  

---

how can i come to same questions after get answer of one question from table,because if i click for one answer and after get the answer i try to come back on same questions i cant access them the questions change, it break up my link and i jummp here and there so plz tell me the way by which i can back to the same page of questions so can continoue my proper notes thanx

2 Answers   ME,

---

How much cement,sand,bricks and water needed for 1square metre brick work?

0 Answers  

---

where can i get the previous question papers for rrb section enginerr (civil)

0 Answers   RRB,

---

WHAT IS THE RATIO OF CEMENT:SAND:COARSE AGGREGADE IN M-20, M-25, M-30, M-35, M-40, M-45, M-50 CONCRETE?

2 Answers   L&T,

---

how to calculate concrete qty for footing using M25 grade 1:1:2 for 731 cft.

9 Answers   Abuilding Lab, L&T, MPSC, Vellapally,

---

how many tonnes equals to one cubic feet?

0 Answers  

---

providing, fixing, removal of pockets of size 100*150*300mm to 500*600*1000mm for foundation. the shuttering material used for making &fixing of pockets shall be removed by the contractor without damaged to pockets. if any damage occurred, the same shall be rectified by the contractor is to handover the pockets to forge shop engineer with proper marking of centre lines, levels etc.

1 Answers  

---